TV Installer Jobs in Houston 77079

What the 77079 route asks of an installer

The housing either side of Memorial Drive in 77079 was largely built between the late 1950s and the 1970s, on generous wooded lots, by builders who used solid material and expected it to last. Sixty years on, most of those houses are on their second or third interior, and a great many are owned by people who have lived in them for decades and intend to stay. That one fact shapes every ticket that comes out of this ZIP.

Customers here are rarely buying a quick mount. They are finishing a den remodel, putting a display into a room that was painted last month, adding a screen to a covered patio, or replacing a television that has hung in the same spot since their children were small. They will notice a bracket sitting a quarter-inch proud of level. They will notice a cable that dips. They will ask what you are about to do before you do it, and a tech who can explain it calmly is worth considerably more on this route than one who is merely quick.

The ticket mix leans this way:

• Large-format displays – seventy-five inches and up is ordinary – in dens, media rooms and primary bedrooms.
• Above-fireplace installs on brick and stone, usually with a recessed outlet box and a fully concealed run.
• Covered-patio and outdoor-kitchen screens, where the hardware and the cable have to survive heat and humidity rather than just look right.
• Whole-room tidy-ups: a display, a soundbar, a subwoofer and four source devices the customer wants to stop seeing.
• Follow-on work, where a television job turns into network cabling or exterior camera coverage a fortnight later.

Attic work is part of the role, and the attics on these houses are deep, hot and full of blown insulation and mature-tree debris. Summer attic runs are scheduled early in the day for good reason, and nobody is asked to stay up there beyond sensible limits.

Paneling, plaster and real masonry: the materials you will actually meet

What separates a competent installer from a frustrated one here is material knowledge. These walls are not the uniform half-inch gypsum of a 2015 build.

Solid-wood and veneer paneling

Dens from this era are frequently panelled, sometimes in genuine hardwood boards and sometimes in plywood veneer, and the paneling is often applied over furring strips rather than directly onto studs. A finder reading through an air gap and a furring strip will lie to you. Probe, measure from a known point such as a corner or a door casing, and choose a fastener long enough to reach real framing rather than long enough to grab panel. Understand also what a mistake costs: a wrong hole in a discontinued veneer is not a patch-and-paint situation.

Plaster over lath

The oldest houses on this route may still carry plaster on rock lath. It is hard, it is brittle at the edge of any hole, and it wants a slow bit and a masonry-capable tool rather than a fast wood bit. Score the surface, drill deliberately, and expect spalling if you rush it.

Stone and brick fireplaces

Genuine masonry chimney breasts are common here and no two behave alike. A rough-face stone wall offers no flat plane to mount against, so shims or a rail system may be required before the bracket ever goes up. Mortar joints and stone faces accept an anchor very differently, and drilling through a face into a hollow flue chase is a mistake that cannot be hidden afterwards. If the assembly is not clear to you, stop before the first hole and call.

Cedar, siding and covered porches

Outdoor mounts on this route usually sit under a deep covered porch with cedar or painted timber detailing. Stainless or coated hardware only, sealant at every exterior penetration, and a drip loop on every cable. The humidity here is year-round, and the fixing has to survive it rather than simply look correct on the day.

Large lots, detached structures and cable that has to travel

Lots in 77079 are wide and frequently deep, and the houses sprawl rather than stack. The consequence is simple: cable runs are long, and the room that needs a signal is often a long way from wherever the equipment lives.

Work that follows from that, regularly:

• Runs from a central closet or a den rack out to a patio, a garage or a detached structure across the lot.
• Attic drops into rooms that were added later and never wired for anything but power.
• Exterior-rated cable, correctly jacketed and supported where it leaves conditioned space, with a proper transition fitting rather than a hole and a bead of caulk.
• Concealment in houses with no accessible attic above the target wall, which means raceway, a built chase, or an honest conversation with the owner about what is actually possible.

Distance also changes the loading. A carry from a long driveway, across a lawn, to a back patio, in July, with an oversized panel, is a two-person task far more often than it looks on paper. Say so when you see it, not after something has been dropped.

Requirements, conduct, compensation and how to apply

What we require

• Demonstrable experience with large-format displays and with hard substrates – paneling, plaster, stone or brick.
• Your own reliable vehicle, able to transport oversized panels flat and protected.
• A complete kit: hammer drill and masonry bits, long level or laser, a stud finder plus a probe, toggles, sleeve anchors and structural lags, fish rods, low-voltage brackets, brush plates, stainless exterior hardware, sealant, drop cloths and shoe covers.
• Current general liability insurance in your own name, with documentation we can keep on file.
• Identity and right-to-work verification and a background check. These homes are occupied, often by long-term residents, and that requirement does not move.

How we work

Assignments are subcontracted and dispatched per ticket, carrying the address, the scope, the screen size, the expected substrate and any property access notes. You may decline any assignment offered. Once accepted, the arrival window is a promise made on our behalf. Finished-work photographs are submitted the same day. Nobody solicits private work from a customer they met on an EVOTECH ticket, and nobody makes a cash arrangement on a doorstep.

Compensation

Rates are set at interview, against the scope you can cover and the experience you bring to it. An installer who can handle stone, conceal a run properly and terminate data cable is a different proposition from one who mounts on drywall only, and the conversation reflects that. We will not publish a figure that would mislead you before we have even spoken.

How to apply

Call (832) 359-2425 or send your details through the contact page. Tell us the largest panel you have installed single-handed, what you have mounted on masonry, whether you carry your own insurance, what you drive, and which days you are genuinely free. EVOTECH has been a licensed and insured low-voltage contractor in this part of Texas since around 2004, covering Katy, Houston, Sugar Land, Richmond, Fulshear and Cypress. Every applicant gets a reply.

Related services

Frequently asked questions