TV Installation Subcontractor Jobs in Houston 77020

One ZIP code, two completely different framing eras

An installer who specialises in one type of house will lose half of this board, because the two halves sit on the same block.

A large share of the original housing east of downtown is small wood-frame construction from the 1920s through the 1950s — bungalows, shotgun-plan houses, modest cottages, most of them on pier-and-beam with eight-foot ceilings and rooms that were never sized for an eighty-inch panel. Then, over the last decade, infill arrived: narrow-lot three-storey townhomes on slab, built in rows, with the living room on the second or third floor and a tall feature wall where a fireplace would be in an older house.

Between those two you also get duplexes and small rental properties, and along the commercial strips a steady run of storefronts, taquerias, barbershops, churches, auto shops and warehouse offices that all want displays on the wall or overhead.

So the honest description of this work is variety. You are not doing the same install eight times. You are switching surface, ceiling height, access and customer type between tickets, sometimes twice in a morning.

Century-old houses: what is actually behind that sheetrock

Open a wall in a pre-war house here and there is a good chance you find diagonal one-by plank sheathing or shiplap behind the drywall. That is why a capacitive stud finder reads solid from corner to corner and gives you nothing usable. Work it the other way: sweep with a strong magnet for the nail lines, tap for the change in tone, then commit one narrow test hole somewhere the bracket itself will sit over afterwards.

Do not assume sixteen inches on centre either. Old framing in this stock runs wide, runs narrow, and goes strange around former door and window openings that were closed up in a remodel. Find two adjacent centres and measure them before you commit.

Load and the floor under you

Pier-and-beam means the structure moves a little, and an aggressive full-motion arm bolted to old, dry framing on an exterior wall is not the same proposition as the same arm on new lumber. If the framing is questionable, blocking added inside the cavity is the right fix, and if the customer will not open the wall, the right answer may be a different wall. That is a call to the office, not an improvisation.

Power is the other recurring problem

Plenty of these rooms have a single receptacle on the far wall. The correct response is a listed in-wall power relocation kit run down to an existing receptacle, or an electrician. It is never a splice inside the cavity and never an extension cord buried in a wall. If the room genuinely has no safe option, say so on the ticket.

Expect shallow, hot attics, and expect additions built with no attic access over them at all — which changes where cable can realistically go before you quote the customer a route.

The new townhome rows and the three-storey climb

The infill townhomes are structurally easy and logistically hard. Framing is new and predictable, the builder usually stubbed a recessed media box behind the intended display location, and concealment takes minutes. The difficulty is getting the panel there.

• Living areas are commonly on the second or third floor, up two switchback stair runs with a landing turn that an eighty-five-inch box will not clear flat. Measure the turn before you carry, and stand the box on end for the turn with a hand on each side.
• Feature walls above a stairwell need proper access equipment. A ladder leaned against a stair rail is how people get hurt, and it is not acceptable on our tickets.
• Corner bead, engineered studs and headers in new construction all read differently on a finder than old lumber. Confirm rather than trust the first beep.
• Parking is the hidden cost. These rows are built on narrow lots with no alley, so plan where the truck sits before you unload, and do not block a neighbour’s drive.

Storefront, church and shop-floor displays

A real share of this ZIP’s work is small commercial, and it is some of the steadiest on the board. Menu boards in portrait above a counter. A run of displays in a waiting area fed from one source. A ceiling drop mount over a shop floor. A tilted screen high on a sanctuary wall so the back rows can see it.

Commercial changes three habits. First, surface raceway and conduit are often acceptable and sometimes specifically required, so the invisible-cable instinct from residential work is not always right. Second, the substrate changes — concrete block and tilt-wall panel take sleeve anchors set in the body of the material, and a lag into a mortar joint is not a mount. Third, you are working in an occupied business: keep the aisle clear, keep the ladder out of the doorway, wear a shirt that identifies you, and work around the customer’s trade rather than stopping it.

Church work is usually scheduled mid-week between services, and the building contact is often a volunteer, so the appointment window needs confirming twice.

How routing and dispatch actually work on this side of town

Addresses here cluster tightly and the drives between them are short, so a good day on this board is several tickets rather than one long one. That only works if the process is tight.

The one rule that never bends: a ticket that does not match the site is our problem to solve, not yours to absorb. Installers who call get a second ticket. Installers who guess create a warranty visit.

Insurance, licensing and how to get on the list

We contract with independent installers who already operate as a business. That means your own vehicle, your own tools, general liability coverage in force, and a completed W-9. Some of the commercial properties on this side of town will also ask for a certificate naming them, so coverage needs to be real and verifiable.

As a low-voltage contractor EVOTECH IT LLC is both licensed and insured, has covered this region for over two decades and carries a 5.0 star rating. The same discipline applies to everyone we contract with: hold the licence that the task requires, use cable rated to sit inside a wall, and leave anything electrical to somebody licensed for electrical.

Practical things we will ask about: whether you can safely handle a large panel with a partner, whether you own your own ladder and access equipment, whether you are comfortable in both a 1930s house and a new-build stairwell, and how fast you return a call.

Pay is a conversation we have when we meet; it tracks the scope of the tickets and what you have already done, and there is no number printed here. To get on the list, ring (832) 359-2425 or submit the contact form with a short summary of your background.

Related services

Frequently asked questions