Start your EVOTECH request in under a minute.
TV Hanging Technician Jobs in Houston, TX 77007
Rice Military, Cottage Grove, Memorial Heights and the converted warehouse blocks around the First Ward. This is a recruitment page for people who hang displays for a living. In 77007 the wall is rarely the hard part of the day — getting an eighty-inch panel to the third floor of a narrow-lot townhouse without marking a stairwell is.
Before the wall, there is the weight
Applicants tend to describe themselves by what they can drill. The part of this role that actually separates people is what happens in the ninety seconds between the carton and the bracket.
A large modern panel is not heavy the way a water heater is heavy. The mass is spread thin across a sheet that wants to flex, and flex is what cracks a screen. A technician who carries a panel by the bezel, or who leans it against a wall face-in for a moment while they reach for a screwdriver, will eventually destroy one. We expect people to work off the carton weight printed by the manufacturer rather than a guess, to keep the panel vertical and supported at the frame, and to decide before lifting — not halfway up a flight of stairs — whether this is a two-person job.
The same judgement applies to the bracket. A mount rated for a given load is rated for a static load on sound structure. Extend an articulating arm out over a room and the leverage at the wall plate changes completely, so an anchor that felt solid flat against the wall can start to work loose. Refusing the extension arm when the wall will not carry it is a core skill here.
Plainly stated: we would rather a technician call the office and say a panel cannot be hung safely today than hang it and hope. Nobody has ever been penalised here for that call.
In 77007 the stairwell decides how many people the job needs
The dominant housing type inside this ZIP code is the narrow-lot townhouse, three levels on a footprint barely wider than a driveway. Garage and entry at ground level, kitchen and living space in the middle, bedrooms and the media room at the top. Almost every display in these homes has to travel two full flights, and the flights are usually switchbacks with a half landing rather than one straight run.
Those turns are where the day is won or lost. A carton that would slide up a straight staircase flat has to be tilted and pivoted at the landing, and there is frequently a pendant light, a handrail return or a stair-wall gallery of framed pictures exactly where the pivot wants to happen. Technicians who work this route learn to walk the stairwell empty-handed first, take the fixtures or the pictures down before anything comes out of the truck, and measure the landing rather than assume it.
The warehouse conversions are a different access problem
North and east of Washington Avenue, in the First Ward and around the Sawyer Yards blocks, a good share of the addresses are converted industrial buildings and newer mid-rise apartments. There the stairs stop being the issue and the building becomes it. Those properties commonly require a booked service elevator slot, a certificate of insurance naming the property, and entry through a service door rather than the lobby. Arriving without that arranged means an hour lost and a customer rescheduled, so we handle the booking from the office — but the technician has to hold to the slot they were given.
There is nowhere to park and that is not an excuse
Streets in Rice Military and Cottage Grove are narrow, kerb space belongs to residents, and most townhouse driveways hold exactly one car. Stage the load in the order it is needed rather than making four trips from a van left two blocks away.
Half this ZIP code has no wooden stud to find
A technician who only knows timber framing will struggle here. The substrate mix inside 77007 runs across at least four categories, and the right fixing is different for each.
| What you meet | Where | What it changes |
|---|---|---|
| Engineered or steel studs | Newer three-storey townhomes | Toggle and channel fixings rather than lag screws straight into timber |
| Solid brick and concrete block | Converted warehouse and loft units | Hammer drill, correct sleeve anchors, mortar joint versus face decision, dust control |
| Shared party wall between units | Attached townhouse blocks | Fire separation — never breached; the mount goes elsewhere |
| Post-tension slab | Most slab-on-grade construction here | No cutting or coring the floor, ever, for any reason |
The party wall and the post-tension slab are absolute limits, not preferences. If the only wall a customer wants is one they share with a neighbour, the display goes elsewhere or onto a floor stand, and the reason is explained politely and written on the ticket. Technicians who can hold that line without sounding evasive do well here.
Concealing cable in these buildings is also its own discipline. There is generally no attic above a top-floor room in a townhouse and no accessible cavity in a masonry loft wall, so the route is either a surface raceway agreed with the owner in advance or a run inside a stud bay with in-wall rated cable and a recessed outlet. Guessing, and then discovering there is no route, is how a two-hour job turns into five.
Most complaints on this route are about the floor, not the television
Because the work happens in tight, finished, and often brand-new interiors, the failures that generate complaints here are rarely technical. They are a smear of brick dust ground into a light oak floor, a gouge in a stairwell wall from a carton corner, or a drill hole opened in the wrong place and then filled badly and left.
- Floor and stair protection down first. Before the panel comes out of the van, not after the first scuff.
- Dust captured at the bit. Masonry and plaster drilling in a finished room means a vacuum held at the hole by a second pair of hands or a collection shroud, not a promise to sweep later.
- Pictures before and after. Condition shots protect the technician at least as much as they protect the customer. An existing dent photographed on arrival stops being your problem.
- Packaging leaves with you. A stack of polystyrene and cardboard left in a townhouse entry is a complaint waiting to be filed, and we do not leave it behind.
- Old equipment handled as agreed. Removal of a previous display or a wall plate is agreed on the ticket in advance; nothing is disposed of on a technician’s own judgement.
EVOTECH IT LLC has worked across this part of Houston for over twenty years and holds a 5.0-star rating, and that rating is made of exactly these small details rather than of anything clever.
Coverage, transport and the checks that come before a first assignment
We are a licensed and insured low-voltage contractor, and anyone taking assignments under that name has to stand up to the same checks we do.
- Your own general liability cover if you are working as an independent contractor, with a certificate we can hold on file. Working vehicle cover as well.
- A vehicle that suits the route. Large cartons, a step ladder and a stocked tool kit have to travel together. A vehicle that cannot be locked while you are three floors up does not work here.
- Your own hand tools and drills, including a hammer drill capable of masonry, a reliable stud and metal scanner, levels, and a torque-sensible driver. Mounts, brackets, in-wall rated cable and plates are supplied against each assignment.
- Identity and background verification, because these assignments put you alone inside private homes and inside buildings that keep their own vendor records.
- Straightforward conduct with customers. No selling on the doorstep, no cash side deals, no quoting extra work — anything additional goes back through the office.
Compensation is discussed at interview and depends on scope, experience, whether you carry your own cover, and the kind of assignments you are able to take. We do not publish a figure on a web page because it would be wrong for half the people reading it.
Putting your name forward for 77007 work
Ring (832) 359-2425, or leave your details on the contact page and we will come back to you. A short call comes first, then a conversation about the kind of work you have done, then a working assessment alongside one of our people before you are sent anywhere alone.
Useful things to have ready: roughly how many years you have been mounting displays, whether you have worked in multi-storey or elevator buildings before, whether you carry your own liability cover, what you drive, and which days you can genuinely commit to. If you have photographs of finished work — particularly cable concealment or a masonry installation — bring them.
If you are strong on the trade but new to working under a contractor, say so plainly. It changes where you start, not whether we are interested.
Related services
Frequently asked questions
Do I need a second person to take 77007 assignments?
What is the largest display I would be asked to hang?
The building has no loading dock and the street is full. How does that get handled?
What happens if a panel is damaged during the lift?
How is pay worked out for this role?
Take on the panels most installers would rather not carry
If you hang displays for a living and a third-floor townhouse does not put you off, call (832) 359-2425 or apply through the contact page. What the role pays is settled in that conversation rather than advertised on this page.
Apply for installer work
Ready for EVOTECH to help?
Before you leave, send the quick version. We will review the page you came from and reply with the clean next step.
